ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||20 December 2010|
|PDF File Size:||16.46 Mb|
|ePub File Size:||3.34 Mb|
|Price:||Free* [*Free Regsitration Required]|
Siddhagiri Metals and Tubes Manufacturer: Link to Active This link will always route to the current Active version of the standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of b16 standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections.
Looking for some more information? Sheet and Strip can be cold rolled to higher strength. Asrm material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost. For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties.
Nickel /Nickel (UNS NO, UNS NO, ASTM B)
Deep drawing is a manufacturing asgm that is used extensively in the forming of sheet metal under tensile and compressive conditions, without altering the sheet thickness. In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling.
Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
Historical Version s – view previous versions of standard. Offer on Fasteners Sitemap.
This abstract is a brief summary of the referenced standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein. Also Each flat rolled product owes its final properties not just in the rolling process itself but to its ast, interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing satm as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
AlloyAlloy Brand: These sheets are made by rolling process. Siddhagiri Metals and Tubes Rating: